Eppendorf FemtoJet Programmable Electronic Microinjector
The FemtoJet enables minute quantities of liquid to be injected into cells. The relevant parameters (injection pressureand injection time) are set using the variable regulators. The INJECT key or connected hand or foot control (not included) or the INJECT key of the connected micromanipulator are used to trigger these two parameters. If no injections are being performed, compensation pressure is applied permanently.
Microinjection into suspension or adherent cells,in combination with Micromanipulator 5171, InjectMan 5179 or InjectMan NI 2: (not included) semiautomatic injection into adherent cells.
Pressure supply: Integrated Compressor
Pressure Display: Can be set to hPa or psi
Programmable parameters: Injection time, injection pressure and compensation pressure
Injection time: 0.0s-99.9 s; can be set in increments of 0.1s
Injection pressure: 0;5 hPa–max. 6,000 hPa (87 psi); can be set in increments of 1 hPa
Compensation pressure: 0; 5 hPa–max. 6,000 hPa (87 psi); can be set in increments of 1 hPa
Clean function: Maximum rinsing pressure of approx. 7,000 hPa (102 psi)
Continuous flow function: 0 hPa–6,000 hPa (87 psi); can be set in increments of 1 hPa
Dimensions (W x H x D): 8.6 x 11 x 6.7 in/22 x 28 x 17 cm
Serial interface: RS-232
*Unit is in excellent condition and comes with operators manual