The model 4200 is an all solid state, general purpose Test Oscillator that provides a main sine wave and an auxiliary sine wave from 10 Hz to 10 MHz. It operates from AC of 115 or 230 V, 50-400 Hz

The main sine wave output is variable from 0 to 10 volts rms open-circuit or 5 volts rms across 50 ohms. Max power output is 1/2 watt with less than 0.1% harmonic distortion. The auxiliary output is a sine wave fixed at 1 volt rms open circuit, and coincident with the main output.

This oscillator has 10 volt amplitude which is a good feature not available on many lower end oscillators.

SPECIFICATIONS:
• Frequency Range: 10 Hz to 10 MHz Continuously Variable
• Frequency Response: Within ±0.25 dB from 10 Hz to 500 kHz rising to ±0.5 dB at 10 MHz into a matched 50 ohm load.
• Eight position pushbutton attenuator calibrated in open circuit voltage and 10 dB steps from +20 to -50 dB plus an infinite resolution vernier calibrated in RMS volts from 0 to 3.16 and 0 to 10
• Attenuator Accuracy: ±0.2dB
• Auxiliary Output: Voltage - Fixed at 1 Vrms open circuit Impedance - 600 ohms DC Component - Zero
• Terminals: Front Panel - BNC for Main Output Aux Ouput Rear Panel - BCN for External Synch
• Power Requirements: 105-125 or 210-250 VAC 1 Phase 50-400 Hz 30 W

NOTE: -5 Modifies the main output from 50 ohm to 75 ohm and the second output from 1V Squarewave to 600 ohm Sinewave..
If you would like us to revert the 4200B to the standard 50 ohms 1V Square we can do so for an additional $20.00 US