Lab-Volt 8090-A Standard Microwave Technology Training System without Microwave Measurement Equipment

Please see below for what is included.

1- 9501  Gunn Oscillator Power Supply

The Gunn Oscillator Power Supply is intended for use with the Gunn Oscillator, Model 9510 (not included). The OUTPUT of the Gunn Oscillator Power Supply connects to the Gunn Oscillator, via a power switch inside the Data

Acquisition Interface. The voltage control knob on the Gunn Oscillator Power Supply allows users to change the voltage applied to the Gunn Oscillator and so vary the output power of the Gunn Oscillator's output signal. The frequency of this signal cannot be varied and is fixed at approximately 10.5 GHz.

Specifications:  Power Requirements: 0.8 A Standard single-phase ac outlet

                            Output: 0-10 V (dc or 1 kHz square wave), 500 mA

1- 9510 Gun Oscillator

1- 9520 Slotted Line

1- 9521 Thermistor Mount

1- 9522 Crystal Detector

1- 9523 Directional Coupler, 10 GHz

1- 9530 Slide-Screw Tuner

2- 9531 Matched Loads

1- 9532 Variable Attenuator

1- 9533 Fixed Attenuator - 6dB

1- 9534 Fixed Attenuator - 30dB

2- 9535 Horn Antenna

1- Assorted Accessories

1- Coaxial Cable with BNC connector, BNC T-connector, Quick Fasteners, Steel Refelctor, Plastic Reflector.

2- 9591 Waveguide Support

1- 9592 Antenna Azimuth Indicator

1- 9593 Amplifier

1- 9599 Storage Tray

1- 8090 Manual